Stenciling with the Laser

Hey all, anyone done laser cutting to create spray stencils? Was thinking of using thick-ish paper settings to cut blue painters tape. Seen on forums people use this as an anti-scorch layer so i assume it’s safe to cut.

Also, side note - I lost the password to the computer but I got trained and my name is in the trained section on the wiki. Am lost pls help

absolutely, yo.

You can get away with pretty thin acetate for this purpose. Cardboard works very well too.

Those exclamation mark looking things in the far back classroom on the wall were done with an experimental stencil I made on the laser cutter, cut on cardboard.

Nice! I’ll post any results i get