The laser alignment is not perfect right now. While the trainers are going to fix it, in the mean time I recommend cutting in the upper left corner of the bed where the laser is strongest.
The red laser is not the one that cuts, it’s just a tracer laser. It’s not aligned perfectly either right now. Don’t pay attention to it
One note about the back left corner: there’s a bump in the honeycomb there that can make it hard to get your material to be the same height over the area of the cut. Particularly if you have a larger cut, it may help to be aware of / avoid it. I find it a little hard to see from the front sometimes, but it becomes quite apparent if one runs their hand over that corner.
I believe these issues have been fixed by now! Thanks to talented Laser Guild members and laser trainers!